Ultimate-support IQ-200 User Manual download pdf (Page 2)

STEP 1

STEP 2

STEP 3

STEP 5 STEP 5

STEP 7

Remove rubber sleeves from back side of the

two top tubes of the IQ-1000 or IQ-2000.

Slide on Small Friction Sleeve to desired

position. Leave at lest 1.25” clearance from the

end of the tube for the 2nd Tier Assembly.

(

)

Tier Assemblies

(

)

Small Friction Sleeves

(

)

Z-nobs

(

)

Washers

(

)

Hex Nuts

Make sure the plastic red triangle is at the joint.

This helps keep the joint open for sliding the 2nd

Tier Assembly into place.

Loosen z-knob until resistance is gone. You do

not have to completely unscrew for hex nut to

adjust second tier.

Pull tier to the outside of the IQ-1000

or IQ-2000.

Fold stand into closed position and push 2nd tiers in. Tighten

2nd tier z-knobs.

While holding the plastic red triangle, slide the

2nd tier into the top tube.

Remove the plastic red triangle when Tier

Assembly is fully in.

Install hand z-knob, washer, and hex nut. It

is important to place the hand knob on the

inside or stand will not fold fully. Also, be

careful not to over-tighten the hand knobs

because over-tightening may case cracking

of the collar.

Repeat steps 1-7 with other 2nd Tier Assembly.

In preparation for STEP 3, use water and soap to

lubricate tube.

IQ-200 SETUP INSTRUCTIONS

IQ-200 TEAR DOWN INSTRUCTIONS

PARTS INCLUDED IQ-200 SETUP INSTRUCTIONS (Continued)

STEP 8

Z-nobs, washer, and hex nuts are assembled together. Remove

hex nuts when adding to tier assemblies.

STEP 2

STEP 4

Plastic red

triangle

1 2

Comments to this Manuals

No comments

Ultimate-support IQ-200 User Manual Page 2

Comments to this Manuals

Related products and manuals for Accessories for music Ultimate-support IQ-200