Ultimate-support IQ-3000 User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
1. Stand the IQ-3000 upright with longer tubes on the floor and
Memory Lock facing you. Open the IQ-3000 up about 12".
2. Loosen Memory Lock knob by turning it counter-clockwise
about five (5) complete turns (being sure not to over loosen).
3. Holding Memory Lock front plate in left hand and back plate
in right hand, rotate plates in opposite directions and align
“hash marks” to set desired height setting. There are nine
(9) height options.
4. Tighten Memory Lock knob clockwise.
5. Open IQ-3000 fully.
STEP 3
STEP 2
STEP 1
STEP 4
STEP 5
1. Set the IQ-1000 or IQ-2000 upright so that the longer leg
tubes are on the floor. Fully open the stand to the pre-set
position (there should be a noticeable resistance as the
plate catches the leg detent).
2. With the Memory Lock facing you, hold top left tube with
left hand and with your right hand pull the Memory Lock
knob toward you, being sure to fully retract the pin from
the Memory Lock plate.
3. Holding the extracted Memory Lock pin with right hand, pivot
the “X” brace with left hand to desired height and release pin.
Be sure the Memory Lock is fully and securely engaged before
placing keyboard on stand.
STEP 1
STEP 2
STEP 3
IQ-3000/IQ-2000/IQ-1000
1. Open stand to fully open position.
2. If stand rocks on an uneven surface, turn black end cap
on bottom tube to a different thickness to correct.
3. End cap on top tube can also be adjusted to secure keyboard.
STEP 1 - 3
IQ- 3000 SETUP INSTRUCTIONS IQ-1000 / IQ -2000 SETUP INSTRUCTIONS
ADJUSTING END CAPS
32
NOTE: Your IQ-1000 or IQ-2000 will open to this height every
time you use it unless a new height is desired. Repeat steps
1-3 to change height setting.
NOTE: Your IQ-3000 will open to this height every
time you use it unless a new height is desired.
Repeat steps 1-5 to change height setting.
Page view 1
1 2

Comments to this Manuals

No comments